Wow. Another week has gone by already. And strangely enough, I have a legitimate DIY to post.
Here is how to make a pillow cover from a shirt. Besides reusing unwanted clothing, this project allows you to use the shirt buttons as a replacement for a zipper or envelope flap and makes your pillow cover removable and cleanable. This is the easiest removable pillow cover you can possibly make.
I started with this thrifted silver gray polyester blouse that was five sizes too big for me. As you may note from my blog header, I am fond of grey and leopard.
I also had pillows I had purchased from Target nearly 10 years ago. The pillow forms are down filled and in great shape, but the covers were getting worn.
The blouse I used had fabric-covered buttons, which made them pretty enough for display. If your shirt or blouse has ugly buttons, they can be turned to the back and the bare side of the pillow can become the front. Or, if you have time on your hands, you can sew on prettier buttons.
I also had pillows I had purchased from Target nearly 10 years ago. The pillow forms are down filled and in great shape, but the covers were getting worn.
You can use an existing pillow cover as your pattern. If you don't have one, measure your pillow's girth and make a paper pattern. Add one inch to the pillow size you measured to allow for a half inch seam allowance.
Button up the shirt. Center your paper square or your old pillow cover so that the buttons run down the middle of the square and pin. Cut out the front piece of your cover. Pin the pattern to the back of the blouse and cut out a back piece of the same size.
Pin the two pieces of fabric together with the wrong sides of the fabric facing out. Stitch all the way around the edge of the fabric using a half inch seam allowance. There is no need to leave an "opening" for turning the pillow right side out.
Trim off any excess fabric from your seam. Unbutton the buttons and turn the pillow right side out. Insert the pillow form through the open "button" seam. Then button up the pillow, as shown below.
The blouse I used had fabric-covered buttons, which made them pretty enough for display. If your shirt or blouse has ugly buttons, they can be turned to the back and the bare side of the pillow can become the front. Or, if you have time on your hands, you can sew on prettier buttons.
